Bus cross-flow

This tank has a 2 1/2" diameter hose connection 9" from the edge of the tank to the center of the hose connection, and a 1/4" NPT flange on the end of the tank.

Note:  the bolt pattern is the same as a #7433 tank

Bus cross flow tank

This tank has a 2 1/2" diameter hose connection 4" from the edge of the tank to the center of the hose connection, and a 1/4" NPT flange on one end of the tank.

Note:  bolt pattern is the same as a #7433 tank

Bus cross flow tank

This tank has a 2 1/2" diameter hose connection 5 1/8" from the edge of the tank to the center of the hose connection, and a 1/4" NPT flange at the one end.

Note:  could be mistaken for a #7415  -  check the bolt holes

Bus cross flow tank

This tank has a 2 3/4" diameter hose connection 6" from the edge of the tank to the center of the hose connection, and a cutout for a CAC.  The grill side of the tank slopes inward.

Bus cross flow tank

Inlet Tank

This tank has a 2" diameter hose connection (3" long) 2 1/2" from the edge of the tank to the center of the hose connection,  an angle bracket offset to the grill side of the tank with a pair of 1/2" slots at 14 7/8" centers, and a 1 1/4" pipe that comes out and up on a 90^o angle to accommodate the fill neck 2 1/2" from the edge of the tank to the center of the pipe.

Outlet Tank

This tank has a 2" diameter hose connection (3" long) 2 1/2" from the edge of the tank to the center of the hose connection, an angle bracket offset to the grill side of the tank with a pair of 1/2" wide slots at 14 7/8" centers, and a pair of 1/4" NPT fittings - one on the engine side opposite the hose connection, and one on the end of the tank by the hose connection.